E.N.A.C. Approval Letter 97/3147/MAE
dated 30 July 1997
The information contained herein supplements the information of
the basic Rotorcraft Flight Manual.
For limitations, procedures and performance data not contained
in this appendix, consult the basic Rotorcraft Flight Manual.
PULSED CHIP DETECTOR
The Pulsed Chip Detector system enables the pilot to burn the particles,
collected by the chip detectors of the lubrication systems.
The pulsed Chip Detector is activated by means of the CHIP BURNER switch
located on the overhead panel.
Two Pulsed Chip Detector configuration exist:
- P/N 109-0811-48-101 - enabling to burn particles collected by the chip
detectors of the main transmission and tail rotor gearbox.
- P/N 109-0811-48-105 - enabling to burn particles collected by the chip
detectors of the main transmission, tail rotor gearbox and engines.
The presence of particles on the chip detectors is pointed out by the activation
of XMSN OIL CHIP, TGB OIL CHIP and#1(#2)OILCHIP caution
messages on EDU 1.
RFM A109E
APPENDIX 4
Page1of5
Rev. 30
To Next Page
Loading...