To Next PageTo Next Page
Need help?Do you have a question about the AHP WELDS alphaTIG 203Xi and is the answer not in the manual?
General| Output Current Range (TIG) | 10-200A |
|---|---|
| Pulse Frequency | 0.5-200Hz |
| AC Frequency | 20-250 Hz |
| AC Balance | 30-70% |
| Welding Processes | TIG, Stick |
| Duty Cycle (TIG/Stick) | 60% @ 200A |
| Input Voltage | 115/230V AC, 50/60Hz |
Instructions for inspecting the unit for shipping damage within 72 hours.
Emphasizes reading the manual and practicing safe operation.
Covers risks like electrical shock, eye damage, fire, and gas cylinder safety.
Addresses inhalation risks, chemical dangers, EMF interference, and physical hazards.
Details safety concerning hot materials, radiation, bystanders, EMF, and electrical terminals.
Overview of the AlphaTIG 203Xi, its technology and features.
Lists standard features, accessories, and details the warranty terms.
Covers operating ranges, duty cycles, input requirements, and dimensions.
Guidelines for generator use and required routine maintenance procedures.
Explains how to adjust HF points and common arc starting issues.
Recommends pure Argon, explains regulator use, and gas flow rates.
Guides on DCEN/DCEP polarity and recommended tungsten types for TIG.
Instructions on proper tungsten grinding angles and techniques for AC/DC.
Discusses electrode types and polarity for stick welding.
Explains front/rear panels, control panel, LCD screen, AC controls, pedal/2t/4t, pulse, and arc starting.
Provides useful TIG settings, Rapid Set notes, torch parts, connector info, and troubleshooting.
