Need help?Do you have a question about the AHP WELDS Alpha-TIG200X and is the answer not in the manual?
General| Input Voltage | 110V/220V |
|---|---|
| Duty Cycle | 60% at 200A |
| Welding Processes | TIG, Stick |
| Frequency | 50/60 Hz |
| Efficiency | 85% |
| Power Factor | 0.93 |
| Insulation Class | F |
| Protection Class | IP21S |
| TIG Welding Thickness | Up to 3/8" (9.5 mm) single pass |
Safety precautions related to electrical hazards during operation.
Advice on avoiding inhalation of welding fumes and gases.
Measures to protect skin and eyes from arc radiation.
Precautions to prevent fires caused by welding sparks.
Recommendation for wearing hearing protection.
Critical warning about the necessity of proper grounding.
Explanation of the welder's advanced inverter technology and its benefits.
Caution about High Frequency start potentially interfering with sensitive electronics.
Identifies and describes various controls and connectors on the welder's front panel.
Notes regarding compatible power sources (110V/220V) and voltage variations.
Step-by-step guide for connecting and preparing the welder for operation.
Detailed steps for operating the welder in DC TIG mode.
Instructions for performing AC TIG welding, including aluminum.
Guidelines for operating the welder in DC Stick (MMA) mode.
Amperage, tungsten diameter, and gas flow rate for TIG welding steel and aluminum.
Recommended electrode size and amperage for stick welding.
Recommendations for selecting tungsten electrodes based on type and process.
Warnings about opening the unit and unauthorized repairs.
Guidelines for operating environment conditions (humidity, temperature).
Information on overload, over-voltage, and ventilation for safe operation.
Details on warranty coverage, exclusions, and responsibilities.
To Next Page
