Chapter VI
Failures
Start switch upon
powering on and the
product doesnot
work
The juicer may give
out unpleasant smell
when used several
times at the
beginning
Shut down while in
use
Work along with the
norse
Failure Analysis and Elimination
Analysis of causes
Poor contact betweena power plug and
socket
This is not abnormal
The voltage is too low
2. Food materials are excessive
3. Service time is too long
. A screw propeller and the juice net are
Troubleshooting
I .Plug the power plug again
2. Replacethe power socket for trying again
3. Sendthe power plug and socket to the
maintenancepoint nearby for detection.
If the juicer still gives out unpleasant smell
after used severaltimes, please sendit to
the maintenancepoint nearby
1. Check whether the voltage is too low
2. Cut off power source to take out the
excessive food materials
3. It is normal fact that a motor will recover
to work after the break
not installed into the proper place to lead
l. The screw propeller and the juice net are
to unsteadyoperation while in service.
well installed.
2. The screw rod for minced meat and the
2. The cover of the container for minced
cover of the container for minced meat
meat and the container for minced meat are
arenot installed into the proper place to
tightly screwed.
leadto unsteadyoperation while in
3. Pleasesendit to the maintenancepoint
service.
nearby
3. Starting motor inside the machine body
is damaged.
10
To Next Page
Loading...
