when the unit is not in use, always press the “OFF” button.
PULSE: Press and hold the button for short or delicate processing tasks. PULSE is used most frequently, as
it gives greater control over food processing and fineness.
LO: low speed, it is suitable for kneading or mixing.
HI: high speed, it is suitable for chopping or slicing/chipping.
Before first use, carefully unpack the food processor and its attachments and remove any package material
or label or stickers. Clean all the parts except the motor base following the instructions in CLEANING
AND MAINTENANCE. Handle the “S” blade or circle blade ass’y with extreme care as they are sharp.
1. Firstly assemble the driving shaft into the motor base, make sure it is clipped into position.
2. Place the jar on the motor base and turn it clockwise until it locks into position. Make sure it is
assembled in place correctly, otherwise the appliance will not operate.
3. Insert the “S” blade into the driving shaft in the jar securely.
Then place the prepared chopping food into the jar. The food must be cut into small size firstly (such as
2cm*2cm*6cm for beef). During chopping, you can add food through the feeding funnel with the pusher,
never using food or finger to push the food into the feeding funnel. When chop fig, the proportion of fig to
honey shall be 380g: 300g and the operation time shall not be more than 30S.
4. Place the lid onto the jar and turn it clockwise until the tab of the lid clicks into slot in the jar handle.
Make sure it is locked in position correctly, otherwise the appliance will not operate.
5. Connect the appliance to power supply. Press the corresponding speed button according to your task.
You can chop up to 400g of following foodstuff,
Hard substance: cheese, dried fruits, and certain vegetables (carrots, celery…),
Soft substance: certain vegetables (onions, spinach…)
Raw and cooked meat (boned and sliced)
CAUTION: The total operating time should not be more than 30 sec.
6. Press the “OFF” button and unplug the appliance after chopping. Grasp blade by its hub and remove.
Unlock jar by turning it in anti-clockwise away from its base, and lift it off. Empty the processed food.
CAUTION: The “S” blade is extremely sharp, handle with care.
1. Disconnect the power supply before cleaning.
2. Empty the jar, dismantle all detachable parts and rinse them in warm soapy water. Extreme caution must
be taken when handling blade as it is very sharp. All the accessories except motor base are dishwasher safe
components, but the temperature setting shall not exceed 70
℃
. Then dry thoroughly.
3. Wipe the outside of base with damp cloth. Never immerse it in water as electric shock is possible to
occur. Then dry thoroughly. Ensure the interlock area is free of food particles
Between processing tasks, pour in some water into the jar, press and hold the PULSE button for several
seconds for quick cleaning.
To Next Page
Loading...