Email: sales@aideepen.com
IV. Precautions for use
1. This module DIY needs to have certain electrician
knowledge, if you are complete freshman, please refer
to the electrician's knowledge before you start. Pay
attention to the safe use of the high voltage part
during installation. When the usage frequency and
power are high, silicon control rectifier requires
external radiator to disspate heat.
2. The power of the module driving load depends on
the power of silicon control rectifier (SCR). BAT41
(40A) can carry a microwave oven transformer,
BAT100 (100A) can carry two microwave oven
transformers, and the recommended one for Loop
transformer is 100A.
3. Do not know the welding time and power of the
welded parts, it is recommended that the welding time
and power be adjusted from small to upper to avoid
damage to the welding pen.
V. Fault cause and troubleshooting
1. The electricity supply does not match the actual
electricity voltage: re-voltage calibration.
2. The solder joint is not secure or soldered: adjust
welding time and power until satisfactory results are
achieved.
To Previous Page
Loading...
Need help?
General