Safe range of use
The flexible lampshade of the table lamp can be
rotated multi-angle, and the lamp pole can be
adjusted up and down.
Diagram for the LED control device wiring method:
Sheath line A is a output wire to connect the LED luminaire.
Output voltage: DC 9V
Max output current: 2A
B is a DC output plug, the inside is positive, and the outside is negative.
Attention!
Product working temperature: 0℃~40℃, relative
humidity: less than 98%.
Products storage temperature: -25℃~40℃, relative
humidity: less than 85%.
Diagram of the product structures
Elastic bolt
Elastic bolt
DC socket
(power supply input port)
Lampshade
Base
Special optical filter
LED control device
Elastic bolt
Control panel
EN
1
4
10
13
7
2
5
11
14
8
3
6
12
15
9
Cautions for the table lamp
1.The table lamp for indoor use only.
2.Do not use the lamp in humid environment.
3.Do not wipe the surface of the lamp with acid or alkaline detergent.
4.Please unplug the power adapter if not using for a long time.
5.Do not disassemble the product and repair it by yourself.
6.Do not place the lamp in direct sunlight or near a heat source.
7.Do not place the table lamp near flammable materials.
8.Do not place the lamp on an uneven surface or on an incline of more
than 6 degrees.
9.Do not place the lamp in soft or flammable places.
10.Do not insert metal pieces or flammable materials into the small gap
of the illuminaire.
11.Unplug the plug immediately if the lamp emits smoke or an unusual
smell.
12.Please do not touch the plug with wet hands.
13.The lamp output wire should not be knotted during use, it should be
stretched naturally.
14.Please do not use multi-functional socket adapter.
15.If the external power cord is damaged, please do not use the lamp
and contact with the nearby dealer for replacement.
To Next Page
Loading...