Click the function key of Transmitter 2, the interface of
PC2 will be transmitted to the Receiver.
2
PC２in use
PC１is in standby
The pairing between the transmitter and receiver has
been disconnected.
Please re-pair the transmitter and receiver.
The antenna signal of the receiver is not being properly
received.
Please reinsert the connection sequence of the receiver
in the following order. First connect the cable with
antenna to the RX and plug it into a power outlet using
an adapter, then plug RX to HDMI input device.
Insufficient power supply.
Troubleshooting
08
To Next Page