Please hold down on receiver for more than 10 seconds
for initialization，then you can re-enter language
selection page.
RX was plugged to a wrong HDMI output port or
choose a wrong HDMI channel.
1. Please connect the RX to the HDMI port of your
selected HDMI channel.
2. If the HDMI port number and channel has no
problem, please test the RX with the other monitor.
The resolution of the receiver is set at default factory
setting at 1080P. You need to enter into receiver
background settings to adjust resolution
1. Use your phone's wifi settings to connect with
receiver.
2. Open your phone's browser and enter into
192.168.203.1，to enter into receiver's setting page.
Click【resolution】,choose【3840x2160p】
To Next Page
Loading...