AIMS Power MPPT+ Series - Chapter 3 User Constants; Structure of User Constants

Chapter 3 User Constants
3.1 The following is the structure of user constants.
GROUP CONSTANTS
MENU Operation
IN =xxx.xV xxx.xAmps
OUT =xxx.xV xxx.xAmps
U-01 Input Voltage
U-02 Input Current
U-03 Output Voltage
U-04 Output Current
U-05 EnergyHarvestToday 1
U-07 EnergyHarvestToday 2
U-08 Stage of Charger
U-09 Date
U-10 Time
U-11 Temperature
U-12 Battery SOC
U-13 Battery Current
U-14 Battery Amp Hours
U-15 Battery Temperature
U-16 Parallel COMM Status
U-17 Serial Number
Initialize A-01 Access Level
A-02 Init Parameters
A-03 Password 1
A-04 Password 2
Programming B Battery Setup B-01 Set Battery Voltage
B-02 Set Battery Type
B-04 Set Battery Capacity
B-05 BAT. MAX Charge Amps
B-06 Set Absorption Voltage
B-07 Set Absorption Time
B-08 Set Float Voltage
B-09 Set Equalize Voltage
B-10 Set MAX EQU. Time
B-11 Set Days Between EQU
B-12 Manual Equalize
C MPPT Setup C-01 Set MPPT Type
C-02 Set Scan Frequency
C-03 Set Percentage VOC
C-04 Percentage EveryTime
C-05 Set Hold Input Volts
D Auxiliary Relay 1 D-01 Set Aux Relay 1 Mode
D-02 Aux RY1 ON Condition
D-03 AuxRY1 OFF Condition
D-04 Aux RY1 MIN. ON time
E Auxiliary Relay 2 E-01 Set Aux Relay 2 Mode
E-02 Aux RY2 ON Condition
E-03 AuxRY2 OFF Condition
E-04 Aux RY2 MIN. ON time
F Parallel Setup F-01 Parallel MODE
F-02
Parallel Addr
O Operator O-01 Set Clock Mode
O-02 Set Time
O-03 Set Date
O-04 Model Number
O-05 Turn OFF Backlight T
O-06 FAN Test
O-07 Software Version
O-08 ***Bootloader***
Data Log G-01 EnergyHarvestToday 1
G-02 EnergyHarvestToday 2
G-03 Set Day LOG # (1-90)
G-04 Day LOG # : kWHr
G-05 Day LOG # @ FLOAT
Average Last xx Days
xxxx kWHr xxxx Ahr
Average Last xx Days
FLOAT xx : xx
U-00
G-07
G-08
Constants Tree