PRECAUTIONS ON INSTALLATION & WIRING
PRECAUTIONS ON INSTALLATION & WIRING
1. Do not connect a power supply other than Aiphone Model P
on NHX-80X. Doing so can cause fire or damage to the unit
2. Do not change or modify NHX equipment
4. Do not open NHX-80X without first unplu
power supply(ies) to prevent electric shock
. Make sure wires are connected properly before plu
6. Keep AC cord free from being pulled or crushed
ence could result in death or seriou
Negligence could result in injury or damag
2. Do not install NHX components in any of the followin
locations, as it may cause the system
to malfunction
air-conditioner, inside a re
ect to environmental conditions, such as oil, dust, chemicals, salt, etc
Places subject to constant vibration or impact
3. Take to earth ground every bed o
metal pipe construction to protect Bedside sub stations and
and-held call buttons from E
1. NHX system is not operable durin
2. In areas where broadcasting station antennas are close by, NHX intercom system may b
wiring at least 30cm, 20” away from A
100~240V wiring, fluorescent lighting, o
4. Do not connect any devices other than the Aiphone Models covered in this Manual
In accordance with CSA C22.2 No.125-M1984, the 4th Edition Standard, For Electromedica
quipment the following NHX
eries units are provided with the "Risque class1 Part" (and in French
"Risque La Pièce class1") markin
Model NHR-7A, Bath Pull-Cord Stations
his Manual is supplied with the NHX-80X Central Control Unit
rior to installation of NHX system, the contents of this Manual must be thorou
peration Manual is supplied with the NHX-50M master station