Air Armor M240 - User Manual

To Next Page

Owner’s Manual

PLEASE READ THIS MANUAL CAREFULLY

BEFORE OPERATING YOUR AIR

COMPRESSOR

Q Industries Inc.

401 East Las Olas Blvd., Suite 130

Fort Lauderdale, Florida 33301

P: 954.689.2263 F 303.568.7700

E Mail: Customerservice@qindustries.net

Parts and Accessories are available at:

www.qindustries-store.net

SPECIFICATIONS

Motor: 12-Volt DC

Fuse: 30 Amp

Maximum working pressure: 120psi.

Maximum re-start pressure: 90psi.

Maximum continuous operating time is 40 minutes.

Supply Air Fitting: Type M

Overheating Protection Circuit:

The unit is equipped with an automatic protection device. In

the event the unit reaches an unsafe operating temperature,

a protection circuit will cut power to prevent damage to the

unit. If the protection circuit activates, immediately

disconnect the unit from the power source and allow it to

cool.

The unit will cool in approximately 15 minutes, depending on

environmental conditions. The protection circuit will

automatically reset itself when the temperature returns to a

safe operating level.

High altitude and certain air temperatures can negatively

affect the unit’s performance.

WARNING:

WARNING! READ ALL INSTRUCTIONS before

operating product. Failure to follow all instructions below

may result in electrical shock, fire and serious injury or

death.

WARNING! Always wear ANSI Z87.1 approved safety

glasses with side shields when operating. Compressed air

and particulate matter can cause eye and soft tissue

damage. Keep air stream away from skin and eyes

WARNING! RISK OF BURNS: Always wear

gloves. Some exposed parts may become hot during use.

WARNING! RISK TO BREATHING:

This

compressor is not designed for and never should be used as

a source of breathable air.

WARNING! RISK OF ELECTRIAL SHOCK:

This

compressor is for use in dry conditions only.

WARNING! RISK OF FALLING: This compressor

will produce vibrations and can “walk.” Only operate at

ground level

WARNING! RISK OF FIRE:

This unit will become hot

during operation. Allow to cool before storing.

WARNING! RISK OF BURSTING: Use only

accessories rated for 120 psi. Always follow tire

manufacturer’s recommended inflation instructions. In most

cases they can be located on the side wall of the tire. If you

are unsure, contact the manufacturer.

WARNING! DO NOT MODIFY: Never drill, modify or

attempt to repair the unit. There are no user serviceable

parts inside.

WARNING! SAFE HANDELING:

Never carry the

unit by the hose or power cord.

WARNING! PAY ATTENTION: Do not leave the unit

running unattended.

WARNING! California Proposition 65

Warning! This product or its power cord contains lead, a

chemical known to the State of California to cause cancer

and birth defects or other reproductive harm. Wash hands

after handling.

WARNING! Do not use an extension cord. Use of an

improper sized cord could result in a risk of fire and electric

shock.

WARNING! EXPLOSIVE GASES: Working around

lead acid batteries may be dangerous. Lead acid batteries

release explosive gases during normal operation, charging

and jump starting. All lead acid batteries produce hydrogen

gas which may violently explode in the presence of

fire or sparks. Do not smoke, use matches or a cigarette

lighter while near batteries. Only work with lead acid

batteries in a well-ventilated area.

To reduce risk of battery explosion, follow the jump start

cable placement instructions published by the manufacturer

of any equipment you use to operate this this product.

Need help?

Do you have a question about the Air Armor M240 and is the answer not in the manual?

Summary

Specifications

Safety Warnings

Risk of Breathing

Compressor is not designed for and never should be used as a source of breathable air.

Electrical Shock Safety

Compressor is for use in dry conditions only.

Fire and Burn Hazards

Unit will become hot during operation. Allow to cool before storing.

Bursting Hazard

Use only accessories rated for 120 psi. Follow tire manufacturer's instructions.

Modification and Repair

Never drill, modify, or attempt to repair the unit. No user serviceable parts inside.

Handling and Operation

Never carry by hose or power cord. Do not leave unit running unattended.

Explosive Gas Warning

Be aware of explosive gases from lead-acid batteries; work in ventilated area.

Operation Set-Up and Power

Operation Set-Up

Place unit on dry level surface, unpack, inspect, and install air filter.

Power Cable Connection

Connect Red clip to Positive 12-volt source, Black clip to Negative ground point.

Stopping and Restarting

At high pressure, start unit then attach tip. Remove tip, then restart unit if needed.

Operating Hints and Troubleshooting

Operating Hints

Do not use with an air tank. Use 20 min rest/off for every 40 min run time.

Troubleshooting

Check battery, fuse, or thermal protection if unit stops. Replace fuse with same rating.

Warranty Information