What to do if the circuit breaker trips when I turn on my Air-Care TurboJet Air Cleaner?
If the circuit breaker trips when you turn on your Air-Care TurboJet Air Cleaner, ensure it's directly connected to the power outlet without using an extension cord. Use only the original 12-gauge (or heavier) 25 ft. power cord. Try an outlet on a line without other devices connected.
Why does my Air-Care TURBOJET MAX have insufficient pull at the duct?
If your Air-Care Air Cleaner has insufficient pull at the duct, you should clean or replace the filters as needed. Also, check for disconnected, collapsed, or broken system ducts and inspect the 12” hose for cracks or holes.
How to fix an Air-Care TURBOJET MAX Air Cleaner when the motor doesn't start?
If your Air-Care Air Cleaner motor doesn't start when you turn on the power switch, check the connections to the motor and control panel. Test the motor and replace it if it's faulty. Look for a manual reset button on the motor. Check and reset the circuit breaker and confirm the electrical outlet has power. If the inverter has a slowly blinking green light, contact Air-Care.
What to do if my Air-Care Air Cleaner has no vacuum with the motor running?
If your Air-Care Air Cleaner has no vacuum even when the motor is running, tighten the shaft adapter bolts and align the wheel and inlet cone. If that doesn't resolve the issue, replace the blower wheel and inlet cone.
How to fix W.G. 4.0 vacuum with motor running in Air-Care TURBOJET MAX Air Cleaner?
To address a W.G. 4.0” vacuum issue with your Air-Care Air Cleaner while the motor is running, replace the HEPA filters as required and clean the 1st and 2nd stage air filters.
General| Brand | Air-Care |
|---|---|
| Model | TURBOJET MAX |
| Category | Air Cleaner |
| Language | English |
To Next Page