EasyManua.ls Logo

Air innovations HEPAir 24S200 - User Manual

Air innovations HEPAir 24S200
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
HEPAir
Installation, Operation
and Maintenance Manual
(Model shown may not be reflective of your model)
Manufactured by:
7000 Performance Drive
North Syracuse, NY 13212
Edition 10-2018
© Air Innovations 2018
Part No. 15H0222-00

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Air innovations HEPAir 24S200 and is the answer not in the manual?

Summary

Receiving, Inspecting and Unpacking the HEPAir Unit

Review the Packing Slip to Verify

Verify model number, options, and accessories against the packing slip.

Check the unit for

Inspect the unit for an electrical power cord and a drain line.

Standard Specifications

Wiring Diagram for HEPAir

Wiring Diagram for HEPAir with Remote Control

HEPAir Specifications Sheet

Safety

Safety Message Conventions

Explains the meaning of DANGER, WARNING, and CAUTION messages.

Danger

Indicates an imminently hazardous situation that could cause death or serious injury.

Warning

Indicates a potentially hazardous situation that could cause death or serious injury.

Caution

Indicates a potentially hazardous situation that could cause minor or moderate injury.

Lockout;Tagout Procedure

Steps to ensure electrical safety by de-energizing the unit before service.

Safety Considerations

Emphasizes qualified personnel, good judgment, and safe practices for installation.

Safety Hazards

Highlights hazards limited to maintenance personnel working around the unit.

Electrical Hazards

Warns about working with dangerously high voltages present in the equipment.

Electrical Shock Hazards

Stresses disconnecting all power sources to avoid electrocution.

Hot Parts Hazards

Advises disconnecting power to heating elements before servicing to prevent burns.

Moving Parts Hazards

Warns about automatically starting motors/blowers and free-wheeling fans.

Main Power Switch

Describes the location and function of the unit's main power switch.

Installation

Pre-installation Test

Steps to test the system for non-visible shipping damage before installation.

Locating the Unit

Guidelines for placing the unit to minimize duct runs and ensure service access.

Planning the Installation

Key considerations for unit placement, ducting, and electrical power.

Mounting the Unit

Instructions and precautions for securely mounting the HEPAir unit.

Wiring the Unit for Power

Safety warnings and steps for matching electrical wiring to the unit.

Installing the Ductwork and Grilles

Guidance on using insulated ductwork for supply and return air.

Inspection and Start-up Checklists

Starting Up and Operating the HEPAir

Maintenance

Troubleshooting

Typical Start-up Problems

Common issues encountered during initial unit startup and their solutions.

Unit Does Not Start-up

Troubleshooting steps for when the unit fails to power on.

Basic Troubleshooting

Advanced Troubleshooting

A. High Discharge Pressure

Causes and solutions for elevated discharge pressure in the refrigeration system.

B. Low Discharge Pressure

Causes and solutions for low discharge pressure in the refrigeration system.

C. Excessive Noise or Vibration

Troubleshooting excessive noise and vibration from components like fans or compressor.

D. Coil Freezing

Diagnosing and resolving evaporator coil freezing issues.

High Pressure Switch has Shut Down the Unit

Instructions to Reset High Pressure Switch

Step-by-step guide to resetting the high pressure safety switch.

Air innovations HEPAir 24S200 Specifications

General IconGeneral
TypePortable Air Conditioner
Cooling Capacity12000 BTU
Power Supply115V / 60Hz
HEPA FilterYes
Warranty1 year limited
Noise Level52 dB(A)

Related product manuals