How to troubleshoot Air Science Laboratory Equipment cabinet that does not start?
If your Air Science Laboratory Equipment cabinet isn't starting or has no power, check that the electrical cord is properly connected and the wall socket is working. You can also try resetting the circuit breaker located on top of the unit.
How to fix low or high airflow in Air Science Laboratory Equipment?
If you're experiencing low or high airflow with your Air Science Laboratory Equipment, try these steps: First, adjust the speed control as needed. If the airflow is low, a faulty fan capacitor could be the problem, and it may need replacement. You can also check for a faulty speed control by shorting it out. Place a jumper wire directly across the connections to the two-speed control leads. If the fan operates, the speed control is defective. If the fan does not run, the speed control is not the problem.
General| Type | PCR workstation |
|---|---|
| Filtration | HEPA Filter |
| Airflow | Vertical laminar flow |
| UV Lamp | Yes |
| Work Surface | Stainless steel |
| Application | PCR applications, DNA amplification, contamination control |
Details on what the 2-year limited warranty covers.
Criteria for selecting an optimal placement for the cabinet.
Specifies necessary environmental and electrical conditions for operation.
Procedures for performance testing, recertification, and operational disclaimer.
Overview of the control system and cabinet start-up procedure.
Guidelines for proper procedures and safety while working inside.
Recommended maintenance tasks and suitable disinfectants.
Procedures for adjusting airflow and replacing filters.
To Next Page
