Choosing the Location of the Turbine Ventilator
PLACEMENT GUIDE FOR TWO TURBINES
PLACEMENT GUIDE FOR THREE TURBINES
END VIEW OF HOUSE
®
Turbine Ventilator with Adjustable Base
Installation Instructions
ROOF PITCH:
Turbine fit roofs with 3/12 to 12/12 pitches.
BEFORE YOU INSTALL - Install only one type of exhaust vent and remove or plug any existing vents (gable vents, roof louvers, ridge vents and
power fans). Install adequate intake ventilation for a Balanced System (50% Exhaust & 50% Intake) in accordance with state and local code requirements.
Intake vents must be installed low at the roof’s edge or in the soffit/undereave. Products such as Air Vent’s Continuous Soffit Vent, Vented Drip Edge,
Undereave Vents and The Edge™ Vent provide the necessary intake ventilation for optimum performance.
TOOLS REQUIRED:
• Phillips screwdriver • Carpenter’s level
• Putty knife • Keyhole or sabre saw
• Utility knife • Hammer
• Drill • Ruler
CUSTOMER SERVICE:
If you have any questions or require special
installation assistance, call our toll-free number
8 a.m. - 5 p.m. (C.S.T.) Monday - Friday
1-800-AIR-VENT (247-8368)
Made in the U.S.A.
PRODUCT FEATURES:
Maintenance-free top and bottom
dual bearing system
All aluminum construction
21 vanes, all riveted top and bottom
High-quality polyproplene bracing system
• rust-free and longer-lasting
• internal spider adds stability
For warranty information refer to enclosed document or visit www.airvent.com
NOTE: Air Vent’s written warranty for this product will be invalid in any instance in which the product was not property installed in accordance with the instructions.
WARNING - T his product has sharp metal edges that can cut your hands. Wear canvas gloves during installation and handling. Use care when
handling unit to prevent damage to the precision-balanced rotor head. This Turbine is for ventilating purposes only and under NO circumstances should it
be installed on a chimney or other hot stack or vent as a draft inducer.
To Next Page
Need help?
General