AIREDALE SmartCool D - Standard Outdoor Unit Features; Outdoor Unit Construction Details; Vertical Air Discharge Configuration; Condenser Coil Specifications

Precision Air Conditioning
SmartCool
TM
– D
Precision Air Conditioning
191
Installation, Maintenance and Commissioning Manual :6877419 02/2013
Standard Features
Construction
Unit cabinets shall be manufactured from galvanised sheet steel coated with epoxy baked
powder paint to provide a durable finish.
Standard unit colour shall be Light Grey (RAL 7035).
Dual position fixing legs shall be supplied attached to the unit via captive bolts and shake
proof washers.
Horizontal Air Discharge
As standard, unit legs are attached and delivered in the horizontal air discharge mode as
are the isolator and fan speed controller.
The legs attached to the top of the unit are for lifting and stacking and shall be removed
and stored safely if not required.
IMPORTANT
Only 2 units may be stacked together.
Vertical
Air Discharge
As standard, unit legs shall be attached and delivered in the horizontal air discharge
mode and shall be repositioned on site to offer vertical air discharge mode, refer to
Dimensions / Weights / Positioning, for details.
IMPORTANT
To ensure the unit isolator and fan speed controller are in the correct orientation
for vertical air discharge please specify at order.
Condenser
Large surface area coil ideally positioned to optimise airflow and heat transfer, shall be
manufactured from refrigeration quality copper tube with mechanically bonded
aluminium fins.
The copper tube shall be internally rifled for improved heat transfer.
The factory test pressure shall not be less than 45Bar
Sweat copper pipe for brazed connection shall be provided
OUTDOOR