What to do if the motor will not start on my Airpress Air Compressor?
First, ensure the power cord is properly plugged in and the switch is in the 'on' position. Check your circuit box for an appropriately sized fuse. If the fuse has tripped, reset it and attempt to restart the unit. If the fuse repeatedly trips, it may be necessary to replace the check valve or contact a service technician.
How to fix excessive moisture in the discharge air from my Airpress Air Compressor?
High humidity environments contribute to excessive condensation. To mitigate this, drain the water from the tank after each use. Consider using water filters on your air line. Remember, water condensation isn't due to a compressor malfunction. Ensure the compressor's air output exceeds your tool's air consumption rate.
What to do if my Airpress Air Compressor has excessive tank pressure?
Move the Auto-On/Off lever to the Off position. If the unit does not shut off, unplug it from the power source and contact a service technician.
What to do if my Airpress Air Compressor is leaking air from the tank body or tank welds?
Never drill into or modify the air tank or its welds, as this weakens the tank. A weakened tank may rupture or explode. If your air compressor tank is leaking, discontinue use of the air compressor.
How to resolve air leaks at the check valve on my Airpress Air Compressor?
A defective check valve can cause a continuous air leak at the pressure release valve when the tank has pressure and the compressor is off. To resolve this, drain the tank, then remove and either clean or replace the check valve.
What to do if the pressure reading drops when using an accessory with my Airpress Air Compressor?
If the pressure drop is excessive while using an accessory, consider replacing the regulator. Remember to adjust the regulated pressure under flow conditions, meaning while the accessory is in use. Some minimal pressure loss is normal during the tool's initial use.
How to fix air leaks between the head and cylinder of my Airpress Air Compressor?
Ensure the head bolts have the proper torque. If the leak persists, it's best to contact a service technician.
Guide to checking and filling the oil level before initial use.
Instructions for installing the air intake filter assembly.
Steps for assembling the compressor's handle.
Daily start-up steps for the air compressor.
Daily shut-down steps for the air compressor.
Instructions for changing the compressor's oil.
Steps for cleaning the air intake filter.
Procedure for checking the tank safety and drain valves.
General| Tank capacity | 5 liters |
|---|---|
| Power | 1.5 HP |
| Voltage | 230 V |
| Maximum pressure | 8 bar |
| Air displacement | 215 l/min |
| Type | Oil-lubricated |
To Next Page
