Installation
3.1.2 Warranty
The warranty duration is 12 months from the date of installation. AIRSYS warrants that its products will be free
from defects in materials and workmanship for a period of 12 months after installation.
The compressor is to be free from defects in material or workmanship for a period of 60 months from date of
installation.
Important. For sites equipped with a generator, when the generator switches to
the primary source of power, the instantaneous voltage may become lower. If this
is the case, the compressor may run at a lower voltage which can decrease the
compressor’s working life. Make sure the Gen-Run signal input is connected
which can protect the compressor. The warranty does not cover damage to the
compressor caused by repetitive out of specification supply voltage during
compressor operation.
AIRSYS will furnish free of charge replacement parts for any component failures that occur within the warranty
period. Customer is responsible for the cost of shipment of replacement material from AIRSYS Cooling
Technologies.
Note: Warranty assumes that an AAST performs the installation and submits the warranty registration card
that accompanied the units in shipment. If the warranty registration card was not filled out and returned to the
supplier, then the warranty will be assumed to expire 12 months from the date of shipment for all components
except the compressor, which will be assumed to expire 60 months from date of shipment.
This warranty does not cover damage to the systems caused by misuse or abuse of the systems such as
physical damage due to mishandling. The warranty does not cover damage caused by force majeure.
Important. Any mishandling of the equipment or modifications to the equipment,
unless agreed upon in writing by AIRSYS, will void the warranty.
3.1.3 Moving the Unit
Forklifts are recommended for moving, loading, unloading, and positioning the WPU for installation. If bands
or ropes are used to create a sling, make sure that excessive force is not applied to the upper edges of the
machines or the package to avoid cosmetic or material damage. When using spacing bars, protective materials
are required around the units to prevent damage. To avoid damage to the units while moving or transporting,
ensure the units always remain in the upright position.
Note: The 28V1B5 unit may not be compatible with pallet jacks due to low pallet height. Loading dock facilities
or lift gate equipped vehicles are recommended when transporting the unit.
Note: A crane will be required to lift the 28V1B5 unit during installation due to its weight (1370 lb/621 kg).
3.1.4 General Safety Rules
Danger. Do not carry out any operation on the machines if you do not have sufficient knowledge
of the operating principles and have not taken all the precautions that permit the system to operate
in safe conditions.
Warning. Work on the electric board only after verifying prime power is disconnected. Do not
apply power to the machine with the covers removed.
Important. Before carrying out inspections, maintenance operations, and safety checks, follow all accident-
prevention standards such as wearing protective goggles and gloves.
To Next Page
Loading...
