AIRSYS UNICOOL 28V1B5 - Page 49

Installation
49
Site name or building serial #: ______________ Name of Tester: _________________________
ASMUC.6 Serial #: ________________________ Title/Position: ___________________________
Date Tested: _____________________________ Contact information: e. ___________________
Ph. ________________
1. Change System Units (Optional)

2. Set the Unit Model

3. Set the Unit Numbers

4. Turn ON the HVAC System

5. Execute Step Test (verifies all functions of each WPU)
•
HVAC Supply Fans
•
HVAC Heaters
•
HVAC Condenser Fans
•
HVAC Mechanical Cooling
•
HVAC Outside Air Damper





6. Set the System Clock

7. Verify Temp and Humidity sensor readings and Setpoint
•
Primary Indoor Temp sensor
•
Humidity sensor
•
External (outside) Temp sensor
•
Confirm indoor temperature setpoint

8. Verify Signal from Generator

9. Verify Smoke/Fire Alarm

10. Verify HVAC Alarms

11. Verify DC-Failover (if installed)

12. Clear Alarm History (Optional)

13. Fill out Warranty Card and send to AIRSYS Cooling Technologies
