Need help?Do you have a question about the AirTap ATI66 and is the answer not in the manual?
Discusses water temperature settings and scald risks, highlighting safe ranges.
Details California law requiring seismic bracing for water heaters and mentions Prop 65.
Specifies requirements for installing the unit in a clean, dry, unobstructed, and safe indoor location.
Provides dimensions, clearance requirements, and ventilation guidelines for enclosed rooms.
Emphasizes compliance with local codes, utility codes, and the National Electrical Code.
Details the need for a dedicated 240V/60Hz single-phase outlet rated for at least 30 amperes.
Specifies the acceptable ambient temperature range for unit installation (20°F - 120°F).
Advises on proper handling and orientation when moving the unit during installation.
Explains how to connect the hot and cold water lines using ¼" NPT connections.
Covers the pre-attached relief and drain valves, including installation caution and drain line requirements.
Describes the two condensate drains (primary and overflow) and hose connections.
Explains thermal expansion in closed water systems and the need for an expansion tank.
Provides crucial instructions on completely filling the unit with water before operation to prevent damage.
Outlines warranty limitations, especially regarding unauthorized energy-saving devices and insulation.
A checklist of critical items to verify before turning on the unit to ensure proper installation.
Lists essential safety measures to follow before and during operation, including handling hydrogen gas.
Explains the function of the temperature-limiting control (TCO) and its manual reset requirement.
Guides users on the initial steps to turn on the unit, emphasizing pre-checks.
Describes the three operating modes (Auto, Econ, Heater) and how to select them.
Details how to adjust the water temperature setting, recommending a range and explaining sensor readings.
Explains the benefits and recommendations for ducting the cool exhaust air from the unit.
Discusses heat pump efficiency in cold climates and suggests mode adjustments based on seasonal temperature.
Provides a detailed explanation of the control panel buttons and their functions.
Describes all indicators and readouts on the unit's display panel for monitoring.
Instructs on checking the Temperature & Pressure (T&P) relief valve annually for proper operation.
Explains the air intake filter, its maintenance (cleaning/rinsing), and access.
Details the anode rod's purpose, inspection schedule, and the consequence of depletion (tank failure).
Advises on periodic draining of the tank to remove sediment and maintain performance and safety.
Describes checks for condensate drain hoses to ensure they are not kinked or clogged.
Provides guidance on preparing the unit for extended periods of non-use, including drainage.
Explains how to respond to unit error alarms, including noting codes and contacting support.
Recommends an annual inspection by qualified service personnel for electrical wiring and controls.
Gives step-by-step instructions for accessing internal components like the filter, anode rod, and heating elements.
Presents a detailed exploded view of the unit with numbered parts for identification.
Outlines the limited lifetime warranty coverage, including what is covered and exclusions.
Specifies the terms of the limited lifetime warranty specifically for the tank assembly.
Provides contact information for the AirGenerate™ Support Department for technical assistance and questions.
General| Brand | AirTap |
|---|---|
| Model | ATI66 |
| Category | Water Heater |
| Language | English |
To Next Page
