Airthereal EVENING TIDE EVT-9K

Questions and Answers

M
Mark CookAug 16, 2025
Why is my Airthereal Water Heater not getting hot enough?
- H
  hollandbonnieAug 16, 2025
  If your Airthereal Water Heater isn't heating the water enough, consider these potential causes: * The user temperature setting might be too low. Try turning up the temperature setting on the unit. * The water flow rate might be too high. Depending on the incoming water temperature and the power output of your model, reduce the water flow. * The voltage might be less than 240 volts. Note that the set voltage of the water heater is 240v, and a lower voltage reduces heating power, possibly requiring a larger power model. * You might be mixing too much cold water. Reduce the amount of cold water mixed, and adjust any anti-scald features on your faucet.
S
Steve FisherAug 18, 2025
How to fix an Airthereal EVENING TIDE EVT-9K that is not heating and the display is off?
- C
  Cameron MasonAug 19, 2025
  If your Airthereal Water Heater isn't heating at all and the digital display is off, it could be due to: * No power or incorrect wiring. Ensure the breakers at the main electrical panel are ON. You may have a faulty breaker or the unit may be wired incorrectly. * A damaged screen or poor screen connection. Consider replacing the screen or reconnecting the wire.
N
njeffersonAug 21, 2025
What does E2 error mean on Airthereal EVENING TIDE EVT-9K?
- M
  Michelle WilliamsAug 22, 2025
  If you see an 'E2' error code (with 5 beeps) on your Airthereal Water Heater, it means the temperature exceeds 149°F/ 65°C. This is a high-temperature warning, not a malfunction. To resolve this: * Select a lower power level or turn down the temperature. * Increase the water flow.
B
Bryan RiveraAug 25, 2025
What to do if Airthereal Water Heater is leaking from the inlet or outlet pipe?
- S
  Steve CollinsAug 25, 2025
  If you are experiencing leakage in the joint of the inlet and outlet pipe of your Airthereal Water Heater, the cause may be: * Poor connection of inlet and outlet pipe. Reconnect the pipe. * The rubber washer is damaged. Replace the washer.
J
Juan SmithAug 28, 2025
What does E5 error mean on Airthereal Water Heater?
- J
  Johnny McgrathAug 28, 2025
  If you see an 'E5' error code (with 5 beeps) on your Airthereal Water Heater, it indicates no over-zero signal, which can be due to: * Low home voltage or abnormal grid input voltage. Check that the voltage meets the installation requirements. * Interference from high-power equipment nearby.
A
andersennatashaAug 30, 2025
What does E1 error mean on Airthereal EVENING TIDE EVT-9K Water Heater?
- S
  Stephanie BlairAug 30, 2025
  If you see an 'E1' error code (with 5 beeps) on your Airthereal Water Heater, it indicates a leakage of electricity. Stop using the water heater and let a professional pinpoint the leaking parts.
N
navarrowandaSep 3, 2025
Why is the water pressure decreasing in my Airthereal EVENING TIDE EVT-9K?
- N
  nleeSep 3, 2025
  If the water pressure of your Airthereal Water Heater is decreasing, the inlet filter or shower may be blocked by water impurities. To resolve this, remove the inlet pipe and clean the inlet filter/shower.
S
Sandra MillerSep 5, 2025
What does error E3 mean on my Airthereal EVENING TIDE EVT-9K?
- M
  Michelle CookSep 6, 2025
  If you see an 'E3' error code (with 5 beeps) on your Airthereal Water Heater, it indicates a failure of the water inlet temperature sensor. Check whether the water inlet temperature sensor terminal is effectively plugged into the main board.
D
Deborah SimsSep 9, 2025
What does error code E4 mean on Airthereal EVENING TIDE EVT-9K Water Heater?
- C
  Casey CarrollSep 9, 2025
  If you see an 'E4' error code (with 5 beeps) on your Airthereal Water Heater, it indicates a failure of the water outlet temperature sensor. Check whether the water outlet temperature sensor terminal is effectively plugged into the main board.
D
Diana HickmanSep 12, 2025
Why is the water temperature unstable on my Airthereal Water Heater?
- M
  Marie Davis PhDSep 12, 2025
  If the water temperature from your Airthereal Water Heater is unstable, it may be due to unstable voltage or water pressure. Ensure the voltage and water pressure are back to normal.