Technical specifications
Power supply: 3 AA 1.5V alkaline (LR6)
Dimensions: Diameter: 105 mm (4.13in)
Height: 45 mm (1.77in)
Weight: 135g including 3 batteries (4.7 oz)
Operational and storage environment:
Temperature: 4 °C (39 °F) to +40 °C (104 °F)
Relative humidity: < 85%
Settling time: TVOC ~ 7 days
See more specs in our Wave Mini Product Sheet
Safety and maintenance
The Airthings Wave Mini is intended for indoor use only.
Avoid direct exposure to sunlight for long periods. Avoid
exposure to direct heat sources. For correct usage, make
sure the detector is operating in the specified temperature
range (see technical specifications).
Exposure to high humidity might permanently alter the
detector sensitivity or damage it.
Do not disassemble. If the detector does not work as
specified or you are in doubt, contact your local dealer or
visit us at Airthings.com.
Use a dry cloth to clean the detector.
When replacing the batteries, pay attention to the polarity
marks. Use AA alkaline (LR6) batteries.
Always snap the mounting bracket to the detector’s rear side
to protect the batteries, even when the detector is not
permanently mounted.
Disposal: electronic equipment.
Limited liability
The instrument is tested and quality-assured by production.
It meets the accuracy values set out in the specifications.
It is recommended to keep the instrument constantly
activated and the batteries in place until drained.
Airthings AS shall not be liable for damages related to failure
or loss of data arising from incorrect operations and handling
of the instrument.
Terms & conditions
airthings.com/terms-use-privacy/
For other languages or additional questions go to
support.airthings.com
The Bluetooth word mark and logos are registered
trademarks owned by the Bluetooth SIG, Inc. and any use of
such marks by Airthings is under license.
Copyright Airthings AS 2018
Regulatory
information
Regulatory information Canada
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
Les changements ou modifications non expressément
approuvés par la partie responsable de la conformité
pourraient annuler l'autorisation de l'utilisateur
d'utiliser l'équipement.
This device complies with Innovation, Science and
Economic Development Canada’s licence- exempt
RSS(s). Operation is subject to the following two
conditions: (1) This device may not cause
interference; and (2) This device must accept any
interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR de l’ISDE
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le
fonctionnement.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
