AIRTRONICS M11X FHSS-3

Questions and Answers

K
Karen WatsonAug 17, 2025
How to fix an AIRTRONICS Control System that does not transmit?
- D
  Diane SmithAug 17, 2025
  If your AIRTRONICS Control System does not transmit, the battery may be low or not fully charged. Try charging the battery.
S
Shawn HillAug 20, 2025
What to do if the alarm on my AIRTRONICS Control System does not stop?
- S
  stewartfaithAug 20, 2025
  If the alarm on your AIRTRONICS Control System doesn't stop, there are several potential causes: * The battery voltage may be low, in which case you should charge the battery. * The S-POS switch might be in the ON position; turn it OFF. * The interval timer could be ON; turn it OFF.
C
carolynvasquezAug 23, 2025
Why does the AIRTRONICS Control System power intermittently go off?
- R
  Ryan FergusonAug 23, 2025
  If the power on your AIRTRONICS Control System intermittently goes off, a loose battery connector may be the cause. Unplug the connector, then reinstall it under the battery.
D
Dakota GarciaAug 26, 2025
What to do if servo movement is slow on AIRTRONICS Control Systems?
- B
  bentleydonaldAug 26, 2025
  If the servo movement in your AIRTRONICS Control System is slow, several factors could be responsible: 1. A negative value might be set in the servo Speed menu. Check the servo Speed settings. 2. The battery could be low. Recharge the battery. 3. The linkage might be stiff or binding. Adjust the linkage to operate freely.
P
pkellerAug 28, 2025
What to do if there is no change in display when keys are pressed on AIRTRONICS Control Systems?
- V
  victoria86Aug 28, 2025
  If there is no change in the display of your AIRTRONICS Control System when keys are pressed, the key lock switch may be ON. Turn the key lock switch OFF.
B
Brittany GarnerAug 31, 2025
Why are left and right steering angles different on AIRTRONICS Control Systems?
- P
  Patrick CainAug 31, 2025
  If the left and right steering angles are different on your AIRTRONICS Control System, even though the settings are the same, the Trim or Sub-Trim may not be centered. Align the trim and Sub-Trim.
S
sherryjohnsonSep 3, 2025
Why does the steering wheel not center on AIRTRONICS Control Systems?
- P
  Philip MooreSep 3, 2025
  If the steering wheel on your AIRTRONICS Control System does not center, the spring tension may be set too loose. Tighten the spring tension.
C
coopersusanSep 5, 2025
What to do if servo will not move to the end of its range on AIRTRONICS Control Systems?
- S
  schmidtjenniferSep 6, 2025
  If the servo on your AIRTRONICS Control System will not move to the end of its range, the D-RATE and EPA settings may be too large. Reset the linkage on the servo for more travel from servo and reset settings.
M
Mary WillisSep 8, 2025
Why is there no key sound when keys are pressed on AIRTRONICS M11X FHSS-3?
- T
  Tyler KaufmanSep 8, 2025
  If there is no key sound when the keys are pressed on your AIRTRONICS Control System, the command signals may be disabled. Check the command signal settings.
A
andre29Sep 12, 2025
What causes the servo not to move when using trim switch on AIRTRONICS M11X FHSS-3 Control Systems?
- D
  Daniel MorrisSep 12, 2025
  If the servo does not move when using the trim switch on your AIRTRONICS Control System, the trim may be outside of the operational range. Reset the trim to zero and center the servo horn and linkage on the servo.

Summary

Introduction

Safety and Compliance

Essential safety precautions and FCC compliance information for the radio control system.

Features and Specifications

System Features and Specifications

Charging the Battery

Battery Charging Safety and Procedures

Safety precautions, warnings, and steps for charging the transmitter battery.

Transmitter and Receiver Binding

Binding Procedure

Step-by-step instructions for pairing the transmitter and receiver.

Menu Flow Chart

Function Page Navigation

Steering Dual Rate

Steering Dual Rate Adjustment

End Point Adjustment

Steering and Throttle EPA

Adjusting left/right steering and throttle/brake servo travel limits.

Exponential

Steering Exponential

Adjusting steering response feel and fine-tuning balance.

Throttle Exponential

Adjusting throttle and brake response for desired feel.

Adjustable Rate Control

Steering ARC Settings

Adjusting steering rate control and its activation.

Throttle ARC Settings

Adjusting throttle and brake rate control and its activation.

Servo Speed

Steering Servo Speed

Adjusting steering servo speed and its activation.

Throttle Servo Speed

Adjusting throttle and brake servo speed and its activation.

Anti-Lock Braking

ALB Settings and Operation

Configuring ALB parameters (point, stroke, lag, speed) and switch operation.

Traction Control

Forward and Return Settings

Configuring forward and return traction control parameters.

Servo Sub-Trim

Servo Sub-Trim Adjustment

Track Timers

Lap Timer Operations

Interval and Countdown Timers

Starting Position

Starting Position Settings

Throttle Hold

Throttle Hold and Activation Settings

Setting throttle hold values and activating/inhibiting the function.

Brake Mixing

Brake Mixing Settings

Compensation Mixing

Compensation Mixing 1 Operations

Servo Monitor

Servo Monitor Usage

Transmitter Set-Up

System User Options

Modulation and Channel Mode

Audio Signal Sound

Tone Settings

Key Assignments

Trim Key Assignment

Fail Safe

Fail Safe Configuration and Checks

Variable Rate Adjustment

Servo Travel Calibration

Custom Menu Display

Customized Menu Creation

Troubleshooting Guide