AIRTRONICS RD6000 SPORT - User Manual

1
This equipment has been tested in accordance with the
requirements contained in the appropriate Commission
regulations. To the best of our knowledge, these tests were
performed using measurement procedures consistent with
industry or Commission standards and demonstrate that the
equipment complies with the appropriate standards. Each
unit manufactured, imported or marketed, as defined in
the Commission’s regulations, will comform to the sample(s)
tested within the variations that can be expected due to
quality production and testing on a statistical basis.
We further certify that the necessary measurments were
made by Kansai Electronic Industry Development Center,
Ikoma Emission Measrement Station, 10830, Takayama-
Cho, Ikoma-City, Nara, 630-01 Japan.

Summary

Section I: Introduction and System Overview

NiCd Battery Charging Information

RD6000 Sport Transmitter Features

An overview of the key program features and functionalities of the RD6000 Sport transmitter.

Airborne System Connections

Audio Low Voltage Alarm

Trainer System Operation

Section II: Common Functions

Implementation of Control Functions

REV (Servo Reversing)

Electronically reversing the direction of servo rotation for each channel to match linkage setup.

CNT (Control Centering)

Fine-tuning the neutral or center position of flight control servos for optimal alignment.

RST (Data Reset)

Model Select and Type Setup

Selecting and setting up different model profiles and configuring the aircraft type (Aero/Heli).

EXP (Exponential)

Adjusting servo sensitivity for softer or sharper control response relative to stick movement.

CPY (Data Copy)

T-CUT (Throttle-Cut)

Function to stop the engine by overriding throttle stick position via a dedicated button.

Section III: RD6000 Sport Users Manual - Aircraft

Aircraft Menu Structure

Aircraft Model Setup and Type

Steps for setting up aircraft models, including initial model selection and type configuration.

EPA (End Point Adjustment)

Limiting the maximum travel of servos on each channel to prevent over-travel or ensure proper range.

G (Landing Gear End Points)

FLAPE (Flaperons)

Alarms

DELTA (Elevons)

A>R (Aileron-Rudder Mix)

V-TAIL (Rudder-Elevator Mix)

T>E (Throttle-Elevator Mix)

Section IV: RD6000 Sport Users Manual - Helicopter

Helicopter Menu Structure

Helicopter Model Setup and Type

Steps for setting up helicopter models, including initial model selection and type configuration.

Pitch Curves (Flight Modes)

Customizing pitch curve points for Normal, Idle-Up, and Throttle Hold flight modes.

Throttle Curves (Flight Modes)

Customizing throttle curve points for Normal, Idle-Up, and Throttle Hold flight modes.

Revolution Mixing

Adjusting tail rotor response to collective/throttle stick movements across different flight modes.

Gyro Adjustment

Setting and adjusting gyro sensitivity for different helicopter flight modes.

TRM (Trim Memory)

D;R (Dual Rate)

Adjusting control throw amounts via a switch for different flight phases or control sensitivity.

DTM (Dynamic Trim Memory)

Compensation Mixers (C-Mix)

Setting up advanced mixing functions to combine control inputs for enhanced helicopter control.

AIRTRONICS RD6000 SPORT Specifications

General

Brand	AIRTRONICS
Model	RD6000 SPORT
Category	Transmitter
Language	English