Need help?Do you have a question about the Airwolf 3D AW3D HD and is the answer not in the manual?
General| Filament Diameter | 3 mm |
|---|---|
| Print Speed | 150 mm/s |
| Connectivity | USB, SD card |
| Heated Bed | Yes |
| Bed Temperature | Up to 120°C |
| Nozzle Temperature | Up to 315°C |
| Layer Resolution | 0.06 mm |
| Nozzle Diameter | 0.5 mm |
| Supported Materials | ABS, PLA, Nylon, TPU |
| Power Requirements | 110V |
To Next Page