Do you have a question about the Airxcel Suburban SF-20Q and is the answer not in the manual?
Model | SF-20Q |
---|---|
Type | Furnace |
Heating Capacity | 20, 000 BTU |
Fuel Type | Propane |
Ignition | Electronic |
Voltage | 12V DC |
BTU Input | 20, 000 BTU |
Ignition Type | Direct Spark Ignition |
Covers fire, explosion, asphyxiation hazards, and carbon monoxide poisoning risks.
Emphasizes that installation and service must be performed by qualified agencies or gas suppliers.
Provides critical steps to follow upon smelling gas, including evacuation and contacting professionals.
Instructs to turn off the furnace and ignition systems during refueling or when the vehicle is in motion.
Warns of severe injury or death from carbon monoxide infiltration from combustion products.
Stresses that failure to maintain the appliance risks fire and carbon monoxide production.
Advises labeling wires, observing motor rotation, and verifying operation post-service.
Warns against vent screens and recommends using only factory-authorized parts for safety.
Details periodic inspections for vent obstructions, soot, burner flame, and keeping the furnace clean.
Covers inspecting furnace installation, vent termination, chamber, and base for soundness and defects.
States the imperative need for proper venting to atmosphere and drawing combustion air from outside.
Notes that initial firing may cause smoking due to manufacturing residues, lasting 5-10 minutes.
Explains the automatic ignition system and reiterates gas smell detection procedures.
Warns against using a furnace that has been submerged due to extreme danger of fire or explosion.
Step-by-step guide for starting the furnace, including thermostat settings and blower operation.
Describes how to observe the burner flame for correct blue color and identifies signs of improper operation.
Details actions to take if ignition fails after multiple attempts and the lockout procedure.
Provides instructions for safely shutting off the gas supply to the furnace.