Need help?Do you have a question about the AIS SLR350Ni and is the answer not in the manual?
Connect Antenna & Ethernet cables first, then the micro-USB power jack.
Requirements for a suitable VHF antenna for AIS signals.
Guide to installing open-source software on the Comar SLR350Ni.
Steps to install the Raspbian operating system on the Raspberry Pi.
Procedure to enable the GPIO serial port for AIS data communication.
Steps to set baud rate and test serial port for receiving AIS data.
Options for installing OpenCPN charting software.
Steps to add a serial connection and set baud rate in OpenCPN.
Instructions for installing OpenCPN with additional plugins.
To Next Page
General