After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
12
Installation (Cont.)
Cold water connection
• Connect the cold water supply hose to a threaded 3/4” connector. During use, the
dishwasher will heat up the water to the required temperature. Make sure the hose is
not kinked or squashed and is fastened tightly in
place (Fig. 4).
• If the water pipes are new or have not been used
for an extended period of time, let the water run
to make sure it is clear and free of impurities. This
step is necessary to avoid the risk of the water inlet
being blocked and damaging the appliance.
• WARNING! Always close the water tap after using the dishwasher.
Drain hose connection
• The drain hose is connected to the drain hose connector at the back of the
dishwasher.
• Insert the end of the drain hose into a drain pipe with a minimum diameter of 40mm,
or let it run into the sink, making sure to avoid bending, crimping or squashing it. The
height of drain pipe must be less than 1100mm from the floor. The free end of the
hose must not be immersed in water to avoid the backflow of water.
• Follow the illustration below (Fig. 5) when installing the drain hose connection.
• The drain hose must be correctly fitted in order to prevent water leaks. It should be
connected at a height of no more than 1.1m (maximum) and secured with a hose clip.
• If you need to drain any excess water from hoses and the sink is higher than 1m
from the floor, you will need to drain the excess water into a bowl or container held
underneath the pipe and lower than the sink.
• If you need a drain hose extension, make sure to use a similar hose that is no longer
than 4 metres, otherwise the cleaning effect of the dishwasher could be reduced.
Fig. 4
Fig. 5
max1100mm
To Next Page
Loading...