Akai AM-67

Digital
component
connections
(for
AM-67
model
only)
Before proceeding
Turn off the power of all components before making connec-
tions.
When connecting components to the DIGITAL 2 and 3 IN ter-
minals, use digital connection cords available from your
audio dealer.
If your DAT deckis equipped with optical input and output ter-
minals, connect it to the DIGITAL 1 (OPTICAL) IN and OUT
terminals of the amplifier using optical fibre cables.
Always replace the terminal caps of the DIGITAL 1 (OPTI-
CAL) IN and OUT terminals when a component is not con-
nected to them.
If your CD player is equipped with both an optical terminal
and analog output terminals, we recommend thatconnection
only be made to the optical terminal for best sound reproduc-
tion.
The digital audio signal is a composite signal made up of the
left and right channel signals. For this reason, separate left
and right INPUT and OUTPUT terminals are not necessary.
DIGITAL COAXIAL
OUTPUT
DIGITAL 1 (OPTICAL) IN/OUT termi-
‘nals (AM-67 model only)
These terminals are for connection of CD SF or DAT decks
„equipped with optical terminals.
Note:
e When you are not using the DIGITAL 1 (OPTICAL) IN/OUT
terminals do not remove the terminal caps.
DAT deck or CD player
Amplifier
CD player .