Akai AM-M459 - Speaker System Setup; Speaker Connection Guidelines; Connecting Speaker Wires; Final Connection Steps

2-2 MODEL AM-M659
fi | err. man Guapry o/a conven/en
®o oo
@ POWER Button
To turn the power on and off.
@ MUTE Indicator
Lights when the MUTE button of the
remote control unit is turned on. The
volume is attenuted by —20 dB (to
1/10).
© Remote Sensor Window
The signals from the remote control
are received by this window.
Keep this window clean.
@ DIGITAL Indicator
Tells you the amplifier is in the CD
mode. In this case, playback signals
are received at the digital input.
© VOLUME Control
To adjust the volume level.
DIGITAL INTEGRATED AMPLIFIER AM-M659
3)
© Input Source Indicators (TAPE,
DAT/VCR, TUNER, CD, PHONO)
Tells you the amplifier is turned on
and which playback source is select-
ed.
@ SOURCE DIRECT Button and Indi-
cator
When engaged, the input signal by-
passes the BASS and TREBLE tone
controls for optimum sound quality.
The indicator lignts when the
SOURCE DIRECT button is turned
on.
© Input Select Buttons (TAPE, DAT/
VCR, TUNER, CD, PHONO)
To select a playback or recording
source you wish to listen to.
© BALANCE Control (LEFT/RIGHT)
To adjust the volume balance of the
left and right channels.
SERVICE MANUAL
9e9o 9
Gexer] ongl[_co_]
| CCA)
0 0
@ TREBLE Tone Control
To adjust the high note (treble) level.
When set to 0, the control has no ef-
fect.
@ BASS Tone Control
To adjust the low note (bass) level.
When set to 0, the control has no ef-
fect.
@ PHONES Jack
Connect the headphone plug to this
jack for private listening.
When connecting the plug, the
speaker output will be cut automati-
Cally.