Press and hold the ALM 1 button on remote control or touch
and hold the ALM 1 control on top panel, while the system is
in the standby mode, the default alarm time (6:00) and the
default alarm mode (iPod
®
) begin flashing in the display.
Continue holding the ALM 1 button until only the HOUR digits
are flashing.
Press the or buttons on the remote control or touch the
TUNE/SKIP or control on the top panel repeatedly to set
the display to the desired wake-up Hour.
Press the ALM 1 button again. The Hour digits stop flashing
and the Minute digits begin flashing.
Press the or buttons on the remote control or touch the
TUNE/SKIP or control on the top panel repeatedly to set
the display to the desired wake up minutes.
Press the ALM 1 button once more to select the wake-up
Alarm Mode (iPod
®
, Radio or Buzzer). One of the 3 Alarm
Mode indicators will be flashing in the display. Press the or
buttons on the remote control or touch the TUNE/SKIP or
control on the top panel repeatedly to select the desired
wake up mode, iPod
®
, Radio, or Buzzer (BUZZ).
Press the ALM 1 button once more. If you selected either the
iPod
®
or Radio Alarm Mode, the Volume Level indicator begins
flashing. Press the or buttons on the remote control or
touch the TUNE/SKIP or control on the top panel – not the
Volume / buttons - repeatedly to set the desired wake
up volume level. Note: if you selected the wake up to Buzzer
alarm mode the volume level is fixed and cannot be adjusted.
When all settings are completed press the ALM 1 button once
more to exit the setting mode and activate Alarm 1. The
display will continue to show all of your alarm settings for a few
seconds and then return to the current time. However the
Alarm 1 indicator ( ) will remain in the display to confirm that
the alarm is active.
ALARM SETTING
47
NOTES:
• Use the Remote Control, you can set the Alarms in STANDBY mode or operation mode.
(The ALM1/ALM2 on the top panel can only be set when the system is in the standby mode.)
• When setting the alarm be sure to observe to confirm that you have set the wake-up hour
correctly.
•
The procedure for setting Alarm 1 and Alarm 2 is the same. The example below is for Alarm
1.
1).
2).
3).
4).
5).
6).
7).
To Next Page
Loading...