Akai APRC-106

USE CLOCK
To setup the time of the unit
1.Connect the ac on(The following operation must be in standby mode).
2.Short according to the TIME button, the time will flash on the lcd display.
3.Press clk-、clk+ to select the number of the time. You can long press function button setup the time format
by 12h or 24h.
4.Press time button to confirm.
5.Then you can set the hour and the minute with the same method of steps 3-4.
Note: if you power the unit after set up the alarm time, then the alarm time will be closed.
USE OTHER IMPORTANT BUTTON
POWER/ALARM OFF BUTTON
-Push this key to power on/off the system.
-Under power off mode, all control keys have no function except
Time, Alarm, Sleep and Snooze.
STOP/SLEEP BUTTON
-In normal working condition, hold on the SLEEP button more than 1.5 sec adjustable sleep time.
*Press this button to set the sleep countdown time. Press once is 00 minutes, press twice 90 minutes, and
press more time will reduce 10 minutes until press 10 times to close sleep function.
USE THE ALARM
To setup the alarm of the unit
1.Connect the AC on.
2.Hold on the TIME button more than 1.5 sec to into alarm setup whenever the unit power on or off.
The time number will flash on the LCD display.
3.Press CLK-、CLK+ to select the hour of the time.
4.Press TIME button to confirm.
5.Then you can set the minute with the same method of steps 3-4.
6.While the alarm time is up, how the alarm ring please look for the form of following:
7.How to shut down the alarm ring when the alarm time is up:
-Press ALARM OFF button to shut down the ring.
-Press SNOOZE button to shut down the ring, then the alarm will ring out after 9 minutes.
8. If want to cancel the alarm, you long press ALARM OFF button, also want to restore alarm,
Long press ALARM OFF button again.
Note:
*In standby state set alarm time.
*Press function button set alarm to choose model (AUX/USB/RADIO/ALARM).
Power Off Erp2 function:
When the unit idle on AUX/USB/SD mode over 10 min. Then the unit will switch into standby mode
automatically.
EN-5