Set pre-set stations
Search for the desired frequency with the PREV button (5) or the NEXT button (16) .
Press the MEMORY button (7).
Use the FOLDER UP/DOWN (8) buttons to select your preferred channel.
Press the MEMORY button (7) when the desired frequency is found.
Repeat the above steps to add more pre-set stations.
To skip to the next preset station, press the FOLDER UP/DOWN buttons (8).
You can also use the number keys on your remote control for this.
CD functions
To select the source mode CD, press the FUNCTION button (3).
The display shows the total number of tracks on the CD.
To start playback, press the PLAY/ PAUSE button (6) once.
During playback, the following functions are available:
To select a track, press the PREV button (5) or the NEXT button (16) until the desired track is set.
To search for a specific point on the disc, hold the PREV button (5) or the NEXT button (16) until
the point is reached and release the button.
To pause playback, press the PLAY/PAUSE button (6) once; to resume playback, press the
button again.
To stop playback, press the STOP button (17).
To Next Page
Loading...
