Akai EA-G90 - Page 6

Recording and Playback using the CHARACTER REVERSE
switch
By emphasizing the levels of the input signal’s high range during record-
ing and by de-emphasizing by the same amount during playback, tape
hiss can be reduced by the same amount. By using the CHARACTER
REVERSE switch during playback, the emphasized characteristics can
be reversed to be come a de-emphasized characteristics without touch-
ing the Channel Frequency Level controls.
Recording
Turn ON the EQUALIZER switch.
. Turn OFF { BL) the REC switch.
Set the tape deck to recording standby mode.
. Adjust the Channel Frequency Level controls over 1 kHz to empha-
size the input signal's high range.
Adjust the recording input level of the tape deck and then put the
tape deck into recording mode.
O PwWN>
Integrated Amplifier
eee Speaker System
)|a0855 ODO BIO 0
~ Tape Deck
Playback
Do not touch the Channel Frequency Level controls.
6. Turn ON ( =) the TAPE MONITOR switch.
7. Turn ON ( -m=) the CHARACTER REVERSE switch.
8. Rewind the tape and begin playback.
Integrated Amplifier
Ui <, » Neem] =
DecdO oO 10000g00
—<—
Speaker System
ooiiioonotiitoo
Tape Deck.