11
After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | info@tempo.org
Setting the heating output
• Activate the appliance by selecting the heat level. To do this, press the
MODE/OFF Function button until the desired heat level is shown in the
display:
1000W: Low heat output: appliance produces an output of 1000 watts
2000W: High heat output: appliance produces an output of 2000 watts
• To put the appliance into standby mode, press the MODE/OFF Function
button until the display shows only the room temperature. The fan will
continue to run for a few seconds until the display backlight turns off and
the heater operation stops.
Selecting the temperature
• Using the “+” (increase temperature) button you can set the target
temperature to a maximum 38°C.
• Using the “-” (decrease temperature)button you can set the target
temperature to a minimum 6°C. The selected target temperature is shown
on the display.
NOTE: As soon as the room temperature has reached the target temperature,
the heater switches off. The fan continues to run. If the room
temperature falls below the target temperature, the heater is
reactivated automatically so that it can maintain the room temperature
at the set level.
Setting the timer
The appliance has a timer that you can use to set the desired heating
duration. Once the period is over, the appliance switches off automatically.
• Press the “H” button to set the hours.
• Press the “M” button to set the minutes.
NOTE: If you press and hold the buttons on the control panel, the values
keep increasing until you release them. The selected time is shown on
the display.
Oscillation (swivel) function
The appliance has an oscillation (swivel) function. This will cause the
appliance to swivel back and forth so that the warm air is more evenly
distributed throughout the room.
• Switch the swivel function on by pressing the Oscillation On/Off button.
• Press the Oscillation On/Off button again to switch off the swivel function.
Operating Instructions (Cont.)
To Next Page
Loading...