9
Display
Here is some general information about how to use the Force display:
Tap a button or option to select it. Use the data dial or –/+
buttons to change its setting or value.
Double-tap a control to access advanced editing options. In some
cases, this will show a numeric keypad that you can use to enter
a value (an alternative to the data dial or –/+ buttons). Tap the
upper-left part of the display to return to the previous view.
In Matrix View, double-tap an empty clip slot in your track to
create a new clip.
Spread two fingers to zoom in (into a section of a waveform, for
example). Pinch two fingers to zoom out.
To Next Page
Loading...
