Akai GX-230D - Page 10

X% 350 9r-cm
Fig. 3
BRAKE BAND SUSPENSION METAL
BRAKE BAND
SPRING SUSPENSION METAL
BRAKE LEVER
CLOTH TAPE
BRAKE BAND
X Confirm that both are
completely separate
Fig. 4
2. BRAKE TENSION ADJUSTMENT (Refer to
Figs. 3 and 4)
1) As shown in Fig. 3, use a 60mm diameter tape the position of the Spring Suspension Metal or
wound on a 5” reel and set both left and right replace the spring.
brake tension to approximately 350 gr-cm. 3) At all modes except stop mode, confirm that
Deviation of left and right tension must be within neither of the brake bands touch the cloth tape
50 gr-cm. ’ around the brake drums.
2)-Brake tension can be adjusted by changing posi-
tion of the Suspended Spring. If necessary, change