Akai GX-265D

REVERSE JOINT D
REVERSE
SOLENOID
D SWITCH LEVER DIRECTION LAMP & MOTOR
REVERSE MICRO SWITCH
SW-6, SW-I9
REVERSE SOLENOID MICRO
SWITCH SW-7
REVERSE JNOINT:
RECORDING AMP RC BOARD
Fig. 6
8.
POSITION
ADJUSTMENT
OF
BRAKE
12.
POSITION
ADJUSTMENT
OF.
REVERSE
SOLENOID
SL-2
(Refer
to
Fig.
4)
SOLENOID
SL-1
(Refer
to
Fig.
6)
Set
the
deck
to
playback
mode,
and
fix
Brake
Sole-
1)
Set
the
deck
to
reverse
mode,
and
adjust
Reverse
noid
at
position
at
which
the
left
and
right
brake
Solenoid
position
so
that
Reverse
Joint
D
acti-
levers
display
180°
angle
relativity.
-
vates
the
Reverse
Solenoid
Microswitch.
2) At this time, be careful that Reverse Joint D does
not contact the body of the microswitch.
9.POSITION ADJUSTMENT OF BRAKE
SOLENOID MICROSWITCH SW-8
(Refer
to
Fig.
4)
13.
D
SWITCH
LEVER
ADJUSTMENT
;
(Refer to Fig. 6)
Set the deck to reverse mode, and adjust D Switch
Lever so that the lever activates the Direction Indi-
cator Lamp and Reel Motor Torque Conversion
Microswitches.
Set the deck to playback mode, and adjust Brake
Solenoid Microswitch position so that the micro-
switch operates properly.
10. BRAKE TENSION ADJUSTMENT
(Refer to Fig. 4) 1.4 INSTALLATION POSITION ADJUST-
Adjust
Spring
Stopper
position
so
that
the
brake
MENT
OF
REVERSE
JOINT
tension
is
350
to
400g.
(Refer
to
Fig.
6)
Adjust Reverse Joint installation position so that
. i -++REV
11.PAUS DJUSTMENT (Refer to Fis. 5 when the deck is set to reverse mode, FWD
Bon M Reterte: Bes 3) Slide Switch of Recording Amp P.C Board (NE-
1) At playback mode, lock Pause Lever.
5037) is completely depressed.
2) Adjust Pause Lock Plate position to obtain a 0.3
to 0.5 mm clearance between Pinch Wheel and
Capstan.
3) When making this adjustment, be careful that the
clearance between Pinch Wheel and Capstan
does not exceed 0.5 mm.
4) Confirm that the Quick Tension Microswitch is
pushed when the Pause Lever is depressed and if
not, adjust with QT Lever B.
ep eS PS SS sh
11