Akai GX-265D

2
ee
ES
EP
ED
TAPE GUIDE
ADJUSTMENT WASHER
% LOWER THE GUIDE DOWN A LITTLE
15. INSTALLATION POSITION ADJUST-
MENT OF HEAD SWITCH SW-3
(Refer to'Figs. 7 and 12)
Adjust Head Switch installation position so that when
the deck is set to reverse mode, the head switch
which is mounted on the head block switches to the
reverse side and that the reverse slide scope is about
0.5 mm.
16. CAPSTAN SHAFT LOOSE PLAY ADJUST-
MENT (Refer to Fig. 8)
Adjust to obtain a clearance of about 0.1 mm bet-
ween the capstan shaft and thrust support angle.
17. OPERATING POSITION ADJUSTMENT
OF TENSION MICROSWITCH SW-14
(Refer to Fig. 9)
Adjust Tension Microswitch position so that when
the Tension Arm drops, the microswitch operates
perfectly to effect stop mode.
ADJUSTMENT WASHE .
LIFT THE GUIDE OF A LITTLE Fig. 10
7 D
a i ae
Fig. 11
18. TAPE GUIDE HEIGHT ADJUSTMENT
(Refer to Fig. 10)
1) Adjust Tape Guide height so that the tape does
not curl between tape guides on Head Base.
2) In case the tape guide is low, adjust by inserting
a U Type Washer on the right side in Fig. 10,
and in case it is high, adjust by inserting a washer
on the left side.
19.REEL TABLE HEIGHT ADJUSTMENT
(Refer to Fig. 11)
1) Load a tape and set the deck to F.FWD and REV
modes. Adjust Reel Table height so that the tape
winds on the center of the reels at both modes.
2) Tape should wind on center of reel regardless
of typeof reel used.
13