Akai GX-636

REEL TABLE
FIXING SCREWS
REEL TABLE
Fig. 9
4. REEL TABLE HEIGHT ADJUSTMENT
(Refer to Fig. 9)
1) Temporarily screw in the fixing screws leaving a
gap of 15mm between the reel table and the
chassis board.
2) Run the tape and adjust the height of the reel
table so that the tape is taken up in the center of
the reel. Tighten fixing screws.
Adjust the height of the right reel table at fast
forward, of the left reel table at rewind.
24
CAPSTAN MOTOR
X O.1 to 2mm
Fig. 10
5. CAPSTAN SHAFT LOOSE PLAY
ADJUSTMENT (Refer to Fig. 10)
Adjust
by
turning
Adjustment
Screw
to
obtain
a
0.1
to 0.2mm degree of loose play when the capstan
shaft is moved as indicated by the arrow mark.
Tighten fixation nut to maintain optimum adjusted
condition. |