5
Section 1. Installation
·
Connect the plug to an adjacent 13amp socket outlet and ensure that the
appliance is not standing on the supply cable.
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
Allow 50mm of space between the back and sides of the freezer, which allows the proper
air circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the freezer not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before
placing food in the freezer compartment.
This freezer requires a standard 220-240V~50Hz electrical outlet with three-prong ground.
The “Green” light indicates that the freezer is properly connected to the electrical power. The light
indicates power supply, and will glow even if the compressor has failed to work and the compart-
-ment is not being cooled.
The door handle is put into the package of user manual .When installation ,please take out and fix
it to the door with screw.
The door key must be inserted on the lock, please place it where children cannot reach when not
using in order to prevent children playing or lost.
To Next Page
Loading...