Akai MPC 2500 Operator's Manual Addendum

MPC 2500 Manual Addendum v1.1
10
Other Improvements
1. DISCARD and EXTRACT functions use selection from the page the function is
initiated from.
∗ DISCARD and EXTRACT functions initiated in the TRIM page will apply
edits to the area between trim start and end points when [F1] (TRIM) is
selected.
∗ DISCARD and EXTRACT functions initiated in the LOOP page will apply
edits to the area between loop start and end points when [F2] (LOOP) is
selected.
2. Added ability to route assignable mix outs in mono.
3. Step recording now follows TC SWING% setting.
4. Copied event data is kept between STEP EDIT and GRID EDIT mode.
∗ When copying events in STEP EDIT mode, the copied data will remain in
memory when switching to GRID EDIT mode.
5. When a Q-Link knob or fader is moved in SLIDER mode, the page is
automatically changed to the moved Q-Link's page.
6. In the L/OUT page of MIXER mode, each individual OUT is now available as a
single mono output, or as a stereo pair.
7. Folder load function loads sequence files when no .ALL file is found.

Akai MPC 2500 Specifications

General

Polyphony	32 voices
Sampling Frequency	44.1 kHz
Sampling Bit Depth	16-bit
Maximum RAM	128 MB
Sequencer	Yes
Type	Sampler/Sequencer
Sequencer Resolution	96 ppq
Digital I/O	S/PDIF In/Out
Power Supply	Internal
Pads	16 velocity and pressure-sensitive
Storage	CompactFlash
Effects	4 internal effects processors
MIDI	2 In, 4 Out
Display	240 x 64 pixel LCD
Analog Outputs	8
Sample Memory	128 MB max
Audio Outputs	8
Audio Inputs	2
Weight	14.5 lbs