."$0D +"'(%$
//25
2
'.'%#
J . ! J
!
0 . #
!
/2
>>#=
8$$."/'%(")
70 %
,/, 0 % #
2
&36<&3!&G"/'
0#)I5-27089
(&9*,D,
%@$$.$"$$
= 4&;564+;6)70*
When you press the [MODE] button, its LED will blink. Pressing [PAD 5] while the [MODE] button’s LED is blinking will display the TRIM page.
@ /,/,
The 'Sample' field is located in the upper left corner of the screen, which displays the sample name. This field chooses which sample's waveform
is to be displayed.
G /,/,)*!
You can change the start point value by turning the [DATA] wheel. If you press the left or right [CURSOR] buttons while holding [SHIFT], you can
move the cursor to higher points within the numeric display to allow for quicker value selection. You can also enter the value directly with the
numeric keypad.
Additionally, the start point can be edited by moving the [Q1] Q-LINK slider.
> 9
When you hit the pad, the MPC5000 plays the sample. The playback method varies depending on the pad.
E5*F9;
The MPC5000 will play the sample from the loop point to the end point repeatedly.
E52F9&;
The MPC5000 will play the part before the loop point.
E5 F9;
The MPC5000 will play the sample from the loop point.
E54F9;
The MPC5000 will play the whole sample.
E5F$E50F
The MPC5000 will first play from the start point to the end point, and then play from the loop point to the end point repeatedly.
%@$$.%$
= /,5,!
To Next Page
Loading...
