Akai MPC 5000 - Page 178

$'I01E
=B>
B 0,,#
G.$.&6(#$%$.I."I/(%

This controls the sample’s pitch. (Sample Programs only)
 
This controls the sample’s volume level.

This controls the cutoff frequency of the Filter.
!
This controls the resonance value of the Filter
"
This control the sample’s pan position.
:
This controls the attack time of the Amp Envelope.
.(
This controls the decay time of the Amp Envelope.
!
This controls the release time of the Amp Envelope
G.$.&(#$%$.I."I/(%

This controls the sample’s pitch. (Sample Programs only)
(
This allows you to alter the HIGH and LOW Range at which the Event will be triggered. (Sample Programs only)

This controls the cutoff frequency of the Filter.
!
This controls the resonance value of the Filter
"
This control the sample’s pan position.
:
This controls the attack time of the Amp Envelope.
.(
This controls the decay time of the Amp Envelope.
!
This controls the release time of the Amp Envelope
C 0,7,#
The value of the controlled parameter is determined by the value set here. The value depends on the type of the parameter selected in the
Parameter' field.
&D
-120 - +120 - This controls the sample pitch with '10' equaling a semitone.
DS
This controls the sample volume level.
&D>>H
This offsets the cut off frequency of the filter. The value set in the PROGRAM mode is used as 0.
+D>>H
This offsets the resonance of the filter. The value set in the PROGRAM mode is used as 0.
D>07
This value switches layers instead of Velocity.
&&:DS
The attack time of the envelope will be replaced with this value.