=B
5DS
The decay time of the envelope will be replaced with this value.
?2)D)25-+)52#)A72-J3
&
A 4->6)I&/5*$'I01E
7$'I01E2%
J ) %* % $'I01E
2
5.35%75+I05#
% $'I01E
04-6)+II7*4-B6)75/5*#
%%
E F9;D
All parameters changed with REAL TIME reset to the original value.
E4F9+&;D
Only the parameter being displayed in Slider page resets to the original value.
72%"
$'I01E 2 "# 1 D
"
1&5 &1 ,, # % $'I01E 2 1
D5%75+I05,,#%$'I01E
2$'I01E%#5%
E&F!$$
$'I01E 2 " # 1 D
4+-576,1&5&1,,75+I05,
,1&5&1,#4+-576&--)I5;*#%$'I01E
" 1 D# 1 D 0
#%$'I01E
04+-576&1)I5;*#%$'I01E"
1D#1D%$'I01E
,75+I05,#4+-576&--)I5;*#%$'I01E
"1D#
0 4+-576 &1 ) I5; *# $'I01E 5% $'I01E
2"1D
G.(#%"1#N
If the [AFTER] button is OFF, when you move the Q-LINK slider/knob, the new Q-LINK Event will be recorded and added to the
existing Q-LINK Events.
If the [AFTER] button is ON, when you move the Q-LINK slider/knob. The new Q-LINK event will be recorded and will erase any
previous Q-LINK Events.
/0;0$'I01E
%$'I01E0;0.%$'I01E0;0
#3
= 0$'I01E#$'I01E
This can be done by moving the selected controller, or navigating to the desired Q-
LINK Controller with the [CURSOR] buttons.
@ /,+,,,&--
This will allow the Q-LINK to act just as a MIDI control. When both the 'Assign' and
'Parameter' fields are set to OFF, MIDI Continuous Controller Numbers from the
selected controller will be recorded to the current sequence.
G / ,, 0;0 &101:&:/
&17&II571:(57