Akai MPC 5000 - Page 25


==

@ 49&1&016!
This will allow sampling from vinyl. If your turntable requires a preamp, make sure the [LINE/PHONO] switch is set to 'PHONO'. If the turntable
requires grounding, connect the grounding wire to the [PHONO GROUND] nut.
,$-$' &
 ()*$+)&
 5$"(#$$)="'(

= 4;080+I012&:6!
This connection is a 48 kHz S/PDIF type digital audio signal.
#"34*1+5
&"34* 67
'&8
"34*&
@ 4+;+6;7
This optical digital output supports 8-channel ADAT format. See 'Setting the ADAT Digital Output' on page 176 for more information on
configuring ADAT output.
 +!#$$)

#:/(
-:/(#,
J,=CG