Akai MPC Studio mk2

366
AIR Stutter
This effect creates mind-blowing glitch effects using a
wide range of volume, pan and pitch stutter effects.
Parameter Value Range Default Value
Intervals 1/64 – ¼ 1/16
Sync Off, On On
Steps 2–64 5
Step Length 0–100% 100%
Freeze Off, On Off
Decay 50.0 ms – 100 s 6.99 s
V
olume -12.0 – 0.0 – 6.0 dB -1.2 dB
Mix 0–100% 100%
Pan Mod 0–100% 50%
Pitch Mod -100 – 0 – +100% 0%
Auto Wah
This effect is a low-pass filter modulated by an envelope that
yields a classic funky “wah-wah”- like sound. The envelope
is triggered by the incoming signal’s amplitude. The amount
of the envelope on the cutoff frequency is user-definable.
Parameter Value Range Default Value
Dry/Wet 0–100 (dry–wet) 100
Resonance 0–100 75
Attack 0–100 30
Release 0–100 30
Cente
r
0–100 50
Sensitivity 0–100 50
Autopan Sync
This effect uses an LFO (tempo-synced to your project) to
move the incoming signal back and forth across the stereo
field, creating a rotary effect.
Parameter Value Range Default Value
Dry/Wet 0–100 (d
r
y–wet) 100
Rate 8 bars – 1/32 1/4
Autopan
This effect uses an LFO to move the incoming signal back
and forth across the stereo field, creating a rotary effect.
Parameter
V
alue Range Default
V
alue
Dry/Wet 0–100 (dry–wet) 100
Rate 0–100 10
Chorus 2-Voice
This effect uses an LFO to modulate the pitch and a delay of
the input signal, which are then added to the dry signal. In
small amounts, this creates the illusion of multiple voices
playing at once. Turn up the Feedback and Amount for
more pronounced “shimmering” and “watery” sounds.
Parameter
V
alue Range Default
V
alue
Dry/Wet 0–100 (dry–wet) 100
Delay 0–100 20
A
mount 0–100 80
Width 0–100 80
Feedback 0–100 50
Rate 0–100 10