Akai MPC Studio mk2

367
Chorus 4-Voice
This effect is the same as Chorus 2-Voice, but adds
additional voices for more pronounced modulation.
Parameter Value Range Default Value
D
r
y/Wet 0–100 (dry–wet) 100
Delay 0–100 20
Amount 0–100 80
Width 0–100 80
Feedback 0–100 50
Rate 0–100 10
Flanger Sync
This effect is the same as Flanger, but syncs to your project
tempo.
Parameter Value Range Default Value
Dry/Wet 0–100 (d
r
y–wet) 100
Rate 8 bars – 1/16 triplets 1/4
Feedback -100 – 100 0
Delay 0–100 20
Width 0–100 80
Flanger
A flanger is a modulated delay to emulate the sound created
when running two analog tape machines in parallel with a
slight time misalignment. Slow Rate settings can produce a
“whooshing” jet engine sound, while faster rates result in
more of a “warble.”
Parameter Value Range Default Value
Dry/Wet 0–100 (dry–wet) 100
Rate 0–100 10
Feedback -100 – 100 0
Delay 0–100 20
Width 0–100 80
Phaser 1
This effect applies multiple ganged all-pass filters to create
“notches,” or sharp spikes, in the frequency spectrum. The
frequencies of these all-pass filters are usually modulated
by an LFO to create a sweeping sound.
Parameter Value Range Default Value
Dry/Wet 0–100 (dry–wet) 100
Rate 0–100 10
Phaser 2
This effect is a variation on Phaser 1.
Parameter Value Range Default Value
Dry
/
Wet 0–100 (dry–wet) 100
Rate 0–100 10
Phaser Sync
This effect is similar to Phaser 1/Phaser 2, but the LFO is
synced to the project tempo..
Parameter Value Range Default Value
Dry/Wet 0–100 (dry–wet) 100
Rate 1 bar – 1/16 triplets 1
/
4