11
Parameter
Family
Parameter Description Range/Options
Filter/MIDI
A: Cutoff (Cut)
The cutoff setting of the 4-pole low-
pass filter.
000 – 100
B: Resonance (Res)
The resonance setting of the 4-pole
low-pass filter.
000 – 100
C: Envelope>Filter (E>F)
How much the filter envelope affects
the current pad's filter cutoff. (When
set to 100, the envelope level will be
added to the cutoff value.)
000 – 100
D: MIDI Note (MID)
The MIDI note sent and received by
the pad.
000 – 127
Utility
A: Trigger Mode (Trg)
How the pad will play its sample when
pressed, which also affects the filter
and amplitude envelopes:
One-Shot: When you press the pad,
the entire sample will play.
Loop: When you press and hold the
pad, the sample will loop until you
release it.
Hold: When you press the pad, the
sample will loop until you press the
pad again.
One Shot (1Sh),
Loop (Lp),
Hold (Hld)
B: Choke Group (C.G)
The pad's choke group. When you
press a pad in a choke group, all
samples assigned to other pads in that
choke group will stop playing.
01 – 16
C: Mono/Poly (M/P)
How the pad plays a second instance
of its sample if you press it again
before its sample finishes playing.
Mono: Pressing the pad before its
sample is finished will cause the
sample to restart.
Poly: Pressing the pad before the
sample is finished will trigger a second
instance of the sample.
Mono (Mon),
Poly (Pol)
D: Velocity (Vel)
How the pad will respond to velocity
(how hard you press it).
On: The force with which you hit the
pad affects its playback volume.
Off: Pressing the pad will play the
sample at full volume.
On,
Off
To Next Page
Loading...
